senorverde
Active Member
- Joined
- May 5, 2016
- Messages
- 51
Great piece As mentioned, it can be confusing at first.One just sold on there last week for $197. But in all honesty anyone with a soldering iron and some multi throw/pole rotary switches could probably build something similar for half the cost. Back when I had a receiver with only one quad tape loop I built a box that could route the tape out signal to any three decoder inputs and then either route the output back to the receiver or a tape unit (and do my monitoring from that). But interesting find no less.
I just received that one yesterday, the seller accepted a much lower offer. Lol I should have waited for this one!One just sold on there last week for $197
That factory box was an eye opener! I never knew that Russound was in North Berwick, Maine. That's only about 20 minutes away from where I'm sitting right now, and I've been by that location an endless number of times! They didn't move far since those days, they're now only about an hour away in New Market, New Hampshire. Wow.
One just sold on there last week for $197. But in all honesty anyone with a soldering iron and some multi throw/pole rotary switches could probably build something similar for half the cost. Back when I had a receiver with only one quad tape loop I built a box that could route the tape out signal to any three decoder inputs and then either route the output back to the receiver or a tape unit (and do my monitoring from that). But interesting find no less.
Enter your email address to join: