kap'n krunch
2K Club - QQ Super Nova
First of all, if any mods this should be moved to another section, please go ahead...
I thought that since there are several QQ members who have lovely ATMOS equipped studios and are great engineers; e.g. @edisonbaggins , and others who are industry veterans , like @Stephen W Tayler , it would be a great way for networking and for artists and management who may look for ATMOS mixing capabilities and come to our great little but powerful community for reference can be directed to great pros...
So, as a Berklee College of Music graduate from Music Production & Engineering in December 1989 back when it was all done to good 'ole 2" tape and then I did a Synclavier course in Full Sail in May 1990 and I was an operator in Estudios Kirios (RIP) Madrid, Spain and I have never stopped making music and recording.
I finally gathered a quite modest 7.1.4 ATMOS studio in my house and have done several mixes from Multis I have found and shared by others, I could share my mixes privately with you so you can listen to my technique which is to emulate the Stereo mix as close as possible and then to open it up...and make sure the mix doesn't fall flat on their faces!
I am Opus Productions USA, the web is opuspruductionsusa.com . If the name sounds familiar is because..well, I have permission to do so...
Am attaching some pics of my modest place which I think sounds very good. The lines show the angles of the speakers. I followed the Dolby specs as close as possible, been trying to have my place come up on the official Dolby ATMOS equipped studios, my contact is Emma Brooks, [email protected] in case there are any questions.
My main gear is:
-11 Adam A7Vs
-Genelec 7630 tank, I mean, Subwoofer
-Apogee Symphony I/O x16
-Furman Power conditioner
-Mac Mini 2019 Intel i7 x 6 running Logic Pro and Nuendo, and I use Ginger Audio Ground Control Sphere to control the delay in ms so there are no phasing issues.
It's all done in the box..for now...
Germán Alberto Sánchez Fas
(kap'n krunch)
panoramic with Ingrid overseeing all..where's Stuart?
the lines are to show the angles suggested by Dolby which are followed as close as possible...
Front
Right
rears
left
heights
don't mistake the humble look, this is a killer setup and I have installed some acoustic isolation...
Now, let's see you guyses setup...
I thought that since there are several QQ members who have lovely ATMOS equipped studios and are great engineers; e.g. @edisonbaggins , and others who are industry veterans , like @Stephen W Tayler , it would be a great way for networking and for artists and management who may look for ATMOS mixing capabilities and come to our great little but powerful community for reference can be directed to great pros...
So, as a Berklee College of Music graduate from Music Production & Engineering in December 1989 back when it was all done to good 'ole 2" tape and then I did a Synclavier course in Full Sail in May 1990 and I was an operator in Estudios Kirios (RIP) Madrid, Spain and I have never stopped making music and recording.
I finally gathered a quite modest 7.1.4 ATMOS studio in my house and have done several mixes from Multis I have found and shared by others, I could share my mixes privately with you so you can listen to my technique which is to emulate the Stereo mix as close as possible and then to open it up...and make sure the mix doesn't fall flat on their faces!
I am Opus Productions USA, the web is opuspruductionsusa.com . If the name sounds familiar is because..well, I have permission to do so...
Am attaching some pics of my modest place which I think sounds very good. The lines show the angles of the speakers. I followed the Dolby specs as close as possible, been trying to have my place come up on the official Dolby ATMOS equipped studios, my contact is Emma Brooks, [email protected] in case there are any questions.
My main gear is:
-11 Adam A7Vs
-Genelec 7630 tank, I mean, Subwoofer
-Apogee Symphony I/O x16
-Furman Power conditioner
-Mac Mini 2019 Intel i7 x 6 running Logic Pro and Nuendo, and I use Ginger Audio Ground Control Sphere to control the delay in ms so there are no phasing issues.
It's all done in the box..for now...
Germán Alberto Sánchez Fas
(kap'n krunch)
panoramic with Ingrid overseeing all..where's Stuart?
the lines are to show the angles suggested by Dolby which are followed as close as possible...
Front
Right
rears
left
heights
don't mistake the humble look, this is a killer setup and I have installed some acoustic isolation...
Now, let's see you guyses setup...